How to deal with wrinkles at the joints of Vents?

1. Prevention before construction
When cutting Vents, ensure the size is accurate to avoid being too large or too small to reduce the possibility of wrinkles during splicing.
2. Flat laying
Before splicing, spread the two ends of the Vents to be spliced ​​flatly and try to keep them in a naturally stretched state.
3. Slow splicing
When performing splicing operations, the movements should be slow and steady, and avoid pulling or pushing hard, which may cause wrinkles in the membrane.
4. Heating treatment
For some minor wrinkles, you can use a hot air gun or heating equipment to properly heat the wrinkled parts, soften them, and gently smooth them with tools. But pay attention to controlling the heating temperature and time to avoid damaging the membrane material.
5. Re-splicing
If the wrinkles are severe and cannot be solved by the above methods, you may need to remove the splicing part and re-splice.
6. Fixing and compacting
After the splicing is completed, use a roller or other compacting tool to apply pressure evenly from the middle of the splicing to both ends to flatten any wrinkles that may exist.